OcNOS-DC 6.4.2 : System Management Guide : System Management Configuration Guide : Telnet Configuration
Telnet Configuration
Overview
Telnet is a TCP/IP protocol used on the Internet and local area networks to provide a bidirectional interactive text- oriented communications facility using a virtual terminal connection. The Telnet program runs, connects it to a server on the network. A user can then enter commands through the Telnet program and they will be executed as if the user were entering them directly on the server console.Telnet enables users to control the server and communicate with other servers on the network. The default port number for Telnet protocol is 23.Telnet offers users the capability of running programs remotely and facilitates remote administration.
Support for In-band Management Over Default VRF
OcNOS supports Telnet over the default and management VRFs via in-band management interface and OOB management interface, respectively.
By default, Telnet runs on the management VRF.
Topology
Telnet topology
Enable and Disable the Telnet Server
 
#configure terminal
Enter configure mode
(config)#no feature telnet vrf management
Disable Telnet feature
(config)#feature telnet vrf management
Enable Telnet feature
(config)#exit
Exit configure mode
Configure the Telnet Server Port
 
#configure terminal
Enter configure mode
(config)#no feature telnet vrf management
Disable Telnet feature
(config)#telnet server port 6112 vrf management
Set Telnet port to 61112
(config)#feature telnet vrf management
Enable Telnet feature
(config)#exit
Exit configure mode
Telnet Client Session
 
#telnet 10.10.10.1 vrf management
Log into remote machine using IPv4 address
Validation Commands
#show telnet server
telnet server enabled port: 6112
 
#show running-config telnet server
feature telnet