OcNOS-DC : Layer 3 Guide : Unicast Configuration Guide : RIPng
RIPng
This chapter contains a basic RIPng configuration example.
Topology
The diagram shows the minimum configuration required to enable RIPng on an interface. R1 and R2 are two routers connected to network 3ffe:11::/64. To enable RIPng, first define the RIPng routing process, then enable RIPng on each interface.
RIPng Topology
Configuration
R1
 
#configure terminal
Enter configure mode.
(config)#interface eth1
Enter interface mode.
(config-if)#ipv6 router rip
Enable RIPng routing on interface eth1.
(config-if)#exit
Exit interface mode, and enter Configure mode.
(config)#interface eth2
Enter interface mode.
(config-if)#ipv6 router rip
Enable RIPng routing on interface eth2.
(config-if)#exit
Exit interface mode, and enter Configure mode.
(config)#router ipv6 rip
Define a RIPng routing process, and enter Router mode.
R2
 
#configure terminal
Enter configure mode.
(config)#interface eth1
Enter interface mode.
(config-if)#ipv6 router rip
Enable RIPng routing on interface eth1.
(config-if)#exit
Exit interface mode, and enter Configure mode.
(config)#interface eth2
Enter interface mode.
(config-if)#ipv6 router rip
Enable RIPng routing on interface eth2.
(config-if)#exit
Exit interface mode, and enter Configure mode.
(config)#router ipv6 rip
Define a RIPng routing process, and enter Router mode.
Validation
show ipv6 rip