neighbor allow-ebgp-vpn
Use this command to allow an eBGP neighbor to be a VPN peer. By default, BGP VPN functionality is allowed only for iBGP peers.
Use the no parameter with this command to remove the configuration.
Command Syntax
neighbor (A.B.C.D|X:X::X:X|WORD) allow-ebgp-vpn
no neighbor (A.B.C.D|X:X::X:X|WORD) allow-ebgp-vpn
Parameters
A.B.C.D
Address of the BGP neighbor in IPv4 format
X:X::X:X
Address of the BGP neighbor in IPv6 format
WORD
Name of a BGP peer group created with the
neighbor WORD peer-group command. When you specify this parameter, the command applies to all peers in the group.
Default
By default, BGP VPN functionality is allowed only for iBGP peers
Command Mode
Address Family-vpnv4 mode and Address Family-vpnv6 mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
(config)#router bgp 200
(config-router)#neighbor 66.66.66.66 remote-as 100
(config-router)#neighbor 66.66.66.66 update-source lo
(config-router)#address-family vpnv4 unicast
(config-router-af)#neighbor 66.66.66.66 allow-ebgp-vpn
(config-router-af)#neighbor 66.66.66.66 activate
(config-router-af)#exit-address-family
Last modified date: 07-13-2023