neighbor dont-capability-negotiate
Use this command to disable capability negotiation. This command is used to allow compatibility with older BGP versions that have no capability parameters used in open messages between peers.
Use the no parameter with this command to enable capability negotiation.
Command Syntax
neighbor (A.B.C.D|X:X::X:X|WORD) dont-capability-negotiate
no neighbor (A.B.C.D|X:X::X:X|WORD) dont-capability-negotiate
For BGP unnumbered mode:
neighbor WORD dont-capability-negotiate
no neighbor WORD dont-capability-negotiate
Parameters
A.B.C.D
Address of the BGP neighbor in an IPv4 format
X:X::X:X
Address of the BGP neighbor in an IPv6 format
WORD
Name of a BGP peer group created with the
neighbor WORD peer-group command. When you specify this parameter, the command applies to all peers in the group.
Default
By default, capability negotiation is disabled
Command Mode
Router mode and BGP unnumbered mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#router bgp 10
(config-router)#neighbor 10.10.0.34 dont-capability-negotiate
For unnumbered peer below configuration is given in BGP unnumbered-mode.
(config)#router bgp 100
(config-router)#bgp unnumbered-mode
(config-router-unnum)#neighbor eth1 dont-capability-negotiate
Last modified date: 07-13-2023