neighbor override-capability
Use this command to ignore received capabilities and use locally configured values.
Use the no parameter with this command to disable this function.
Command Syntax
neighbor (A.B.C.D|X:X::X:X|WORD) override-capability
no neighbor (A.B.C.D|X:X::X:X|WORD) override-capability
For BGP unnumbered mode:
neighbor WORD override-capability
no neighbor WORD override-capability
Parameters
A.B.C.D
Address of the BGP neighbor in an IPv4 format
X:X::X:X
Address of the BGP neighbor in an IPv6 format
WORD
Name of a BGP peer group created with the
neighbor WORD peer-group command. When you specify this parameter, the command applies to all peers in the group.
Default
By default, override-capability is disabled
Command Mode
Router mode and BGP unnumbered mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#router bgp 12
(config-router)#neighbor 10.10.10.10 override-capability
For unnumbered peer below configuration is given in BGP unnumbered-mode.
(config)#router bgp 100
(config-router)#bgp unnumbered-mode
(config-router-unnum)#neighbor eth1 override-capability
Last modified date: 07-13-2023