neighbor passive
Use this command to make a BGP neighbor passive.
Use the no parameter with this command to disable this function.
Command Syntax
neighbor (A.B.C.D|X:X::X:X|WORD) passive
no neighbor (A.B.C.D|X:X::X:X|WORD) passive
For BGP unnumbered mode:
neighbor WORD passive
no neighbor WORD passive
Parameters
A.B.C.D
Address of the BGP neighbor in an IPv4 format
X:X::X:X
Address of the BGP neighbor in an IPv6 format
WORD
Name of a BGP peer group created with the
neighbor WORD peer-group command. When you specify this parameter, the command applies to all peers in the group.
Default
By default, neighbor passive is disabled
Command Mode
Router mode and BGP unnumbered mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#router bgp 12
(config-router)#neighbor 10.10.10.10 passive
For unnumbered peer below configuration is given in BGP unnumbered-mode.
(config)#router bgp 100
(config-router)#bgp unnumbered-mode
(config-router-unnum)#neighbor eth1 passive
Last modified date: 07-13-2023