match ipv6 next-hop prefix-list
Use this command to match entries of a prefix-list. The route specified by the policies might not be the same as specified by the routing protocols. Setting policies enable packets to take different routes depending on their length or content. Packet forwarding based on configured policies overrides packet forwarding specified in routing tables.
Note: This command is valid for BGP and IS-IS only.
Use the no parameter with this command to disable this function
Command Syntax
match ipv6 next-hop prefix-list WORD
no match ipv6 next-hop prefix-list WORD
Parameters
WORD
IPv6 access list name.
Default
No default value is specified
Command Mode
Route-map mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#route-map rmap1 permit 3
(config-route-map)#match ipv6 next-hop prefix-list new
Last modified date: 07-13-2023