set ip next-hop
Use this command to set the specified next-hop value.
Use the no parameter with this command to turn off the setting.
Note: This command is valid for BGP, OSPF, and RIP only.
Command Syntax
set ip next-hop A.B.C.D
no set ip next-hop (A.B.C.D|)
Parameter
A.B.C.D
IP address of the next-hop.
Default
By default, set ip next hop A.B.C.D is disabled
Command Mode
Route-map mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#route-map mymap permit 3
(config-route-map)#set ip next-hop 10.10.0.67
Last modified date: 07-13-2023