mpls traffic-eng
Use this command to configure a routing command level for MPLS Traffic Engineering (MPLS-TP).
Use the no parameter with this command to remove this configuration.
Command Syntax
mpls traffic-eng (level-1|level-2|router-id)
no mpls traffic-eng (level-1|level-2|router-id)
Parameters
level-1
Run MPLS-TE only at IS-IS level 1
level-2
Run MPLS-TE only at IS-IS level 2
router-id
Traffic Engineering stable IP address for system
Command Mode
IS-IS Router mode
Examples
#configure terminal
(config)#mpls traffic-eng level-1
(config-router)#no mpls traffic-eng level-1
Last modified date: 07-13-2023