tunnel-name
Use this command to configure tunnel name for the MPLS transport tunnel to be used for the MPLS layer-2 virtual circuit.
Use the no parameter with this command to delete tunnel name from the MPLS layer-2 virtual circuit.
Command Syntax:
tunnel-name NAME
no tunnel-name
Parameters
NAME
Identifying name for MPLS Tunnel
Default
By default, tunnel-name is disabled
Command Mode
Configure Pseudowire mode
Applicability
This command was introduced before OcNOS version 1.X
Example
#configure terminal
(config)#mpls l2-circuit mycircuit 45678 1.2.3.4
(config-pseudowire)#tunnel-name pe1-to-pe2
Last modified date: 07-13-2023