tunnel-select-policy
Use this command to configure tunnel selection policy name for the MPLS transport tunnel to be used for the MPLS layer-2 virtual circuit.
Use the no parameter with this command to delete tunnel selection policy name from the MPLS layer-2 virtual circuit.
Command Syntax
tunnel-select-policy POLICYNAME
no tunnel-select-policy
Parameters
POLICYNAME
Selection policy name for MPLS Tunnel
Default
By default, tunnel-select-policy is disabled
Command Mode
Configure Pseudowire mode
Applicability
This command was introduced before OcNOS version 1.X
Example
#configure terminal
(config)#mpls l2-circuit mycircuit 45678 1.2.3.4
(config-pseudowire)#tunnel-select-policy policy1
Last modified date: 07-13-2023