vccv cv-type
Use this command to configure the VCCV control verification for MPLS layer-2 virtual circuit.
Use the no parameter with this command to disable control verification from MPLS layer-2 virtual circuit.
Command Syntax:
vccv cv-type (type-1|type-2|type-3|type-4)
no vccv cv-type (type-1|type-2|type-3|type-4)
Parameters
type-1
BFD IP/UDP-encapsulated for PW Fault Detection only
type-2
BFD IP/UDP-encapsulated for PW Fault Detection and AC/PW Fault Status Signalling
type-3
BFD PW-ACH-encapsulated for PW Fault Detection only
type-4
BFD PW-ACH-encapsulated for PW Fault Detection and AC/PW Fault Status Signalling
Default
By default, vccv is disabled
Command Mode
Configure Pseudowire mode
Applicability
This command was introduced before OcNOS version 1.X
Example
#configure terminal
(config)#mpls l2-circuit mycircuit 45678 1.2.3.4
(config-pseudowire)# vccv cv-type type-1
Last modified date: 07-13-2023