OcNOS-RON-6.3.1 : Multi-Protocol Label Switching Guide : Multi-Protocol Label Switching Configuration Guide : PW Redundancy Configuration : PE2
PE2
 
#configure terminal
Enter configure mode.
(config-if)#interface lo
Identify the loopback interface to configure (lo).
(config-if)#ip address 68.68.68.68/24
Set the IP address of the loopback interface to 68.68.68.68/24.
(config-if)#exit
Exit interface mode.
(config)#interface eth3
Enter interface mode.
(config-if)#label switching
Enable label switching on the interface.
(config-if)#ip address 33.0.0.68/24
Set the IP address of the interface to 33.0.0.68/24.
(config-if)#exit
Exit interface mode.
(config)#router ospf
Enter the Router mode for OSPF.
(config-router)#network 68.68.68.68/32 area 0
(config-router)#network 33.0.0.0/24 area 0
Define the Network on which OSPF runs and associate the area ID (area 0) with the interface.
(config-router)#exit
Exit Router mode and return to Configure mode.
(config)#router ldp
Enter the Router mode for LDP.
(config-router)#transport-address ipv4 68.68.68.68
Configure loopback address as LDP transport address.
(config-router)#pw-status-tlv
Enable the PW Status TLV (pw-status-tlv).
(config-router)#targeted-peer-ipv4 66.66.66.66
Configure LDP targeted peer to PE1.
(config-router)#targeted-peer-ipv4 67.67.67.67
Configure LDP targeted peer to PE3.
(config-router)#exit
Exit Router mode and return to Configure mode.
(config)#interface eth3
Enter interface mode.
(config-if)#enable-ldp ipv4
Enable IPv4 LDP on the interface.
(config-if)#exit
Exit interface mode.
(config)#mpls l2-circuit vc1 10 66.66.66.66
Configure a Virtual Circuit for PE2. In this example, vc1 is the VC name, 10 is the VC ID, and 66.66.66.66 is the endpoint IP address.
(config-pseduowire)#exit
Exit pseudowire mode.
(config)#mpls l2-circuit vc2 20 67.67.67.67
Configure another Virtual Circuit for PE2. In this example, vc2 is the VC name, 20 is the VC ID, and 67.67.67.67 is the endpoint IP address.
(config-pseduowire)#exit
Exit pseudowire mode.
(config-if)#interface eth2
Enter interface mode.
(config-if)#switchport
Switch to Layer 2 mode.
(config-if)#mpls-l2-circuit vc1 ethernet
Bind VC1 as an Ethernet circuit.
(config-if)#mpls-l2-circuit vc2 ethernet
Bind VC2 as an Ethernet circuit.
(config-if)#exit
Exit interface mode.
Last modified date: 07-13-2023