OcNOS-RON-6.3.1 : Multi-Protocol Label Switching Guide : Multi-Protocol Label Switching Configuration Guide : PW Redundancy Configuration : PE3
PE3
 
#configure terminal
Enter configure mode.
(config-if)#interface lo
Identify the loopback interface to configure (lo).
(config-if)#ip address 67.67.67.67/32
Set the IP address of the loopback interface to 67.67.67.67/32.
(config-if)#exit
Exit interface mode.
(config)#interface eth2
Enter interface mode.
(config-if)#label-switching
Enable label switching on the interface.
(config-if)#ip address 22.0.0.67/24
Set the IP address of the interface to 22.0.0.67/24.
(config-if)#exit
Exit interface mode.
(config)#router ospf
Enter the Router mode for OSPF.
(config-router)#network 67.67.67.67/32 area 0
(config-router)#network 22.0.0.0/24 area 0
Define the Network on which OSPF runs and associate the area ID (area 0) with the interface.
(config-router)#exit
Exit Router mode and return to Configure mode.
(config)#router ldp
Enter the Router mode for LDP.
(config-router)#transport-address ipv4 67.67.67.67
Configure loopback address as LDP transport address.
(config-router)#pw-status-tlv
Enable the PW Status TLV (pw-status-tlv).
(config-router)#targeted-peer-ipv4 68.68.68.68
Configure LDP targeted peer for PE2.
(config-router)#targeted-peer-ipv4 69.69.69.69
Configure LDP targeted peer for PE4.
(config-router)#exit
Exit Router mode and return to Configure mode.
(config)#interface eth2
Enter interface mode.
(config-if)#enable-ldp ipv4
Enable IPv4 LDP on the interface.
(config-if)#exit
Exit interface mode.
(config)#mpls l2-circuit vc3 30 68.68.68.68
Configure a Virtual Circuit for PE3. In this example, vc3 is the VC name, 30 is the VC ID, and 68.68.68.68 is the endpoint IP address.
(config-pseduowire)#exit
Exit pseudowire mode.
(config)#mpls l2-circuit vc4 40 69.69.69.69
Configure another Virtual Circuit for PE3. In this example, vc4 is the VC name, 40 is the VC ID, and 69.69.69.69 is the endpoint IP address.
(config-pseduowire)#exit
Exit pseudowire mode.
(config-if)#interface eth1
Enter interface mode.
(config-if)#switchport
Switch to Layer 2 mode.
(config-if)#mpls-l2-circuit vc1 ethernet
Bind VC3 as an Ethernet circuit.
(config-if)#mpls-l2-circuit vc2 ethernet
Bind VC4 as an Ethernet circuit.
(config-if)#vc-mode standby
Configure VC mode as standby.
(config-if)#exit
Exit interface mode.
Last modified date: 07-13-2023