area interface network-type
Use this command to set the OSPF network type on the current interface.
Use no form of this command to unset the OSPF network type on the current interface.
Command Syntax
area (A.B.C.D|<0-4294967295>) interface IFNAME network-type (broadcast|non-broadcast|point-to-multipoint (non-broadcast|)|point-to-point)
no area (A.B.C.D|<0-4294967295>) interface IFNAME network-type
Parameters
A.B.C.D
OSPF area ID as an IPv4 address.
<0-4294967295>
OSPF area ID as a decimal value.
IFNAME
Specify the interface name.
broadcast
Sets the network type to broadcast.
non-broadcast
Sets the network type to NBMA.
point-to-multipoint
Sets the network type to point-to-multipoint..
non-broadcast
Sets the network type to NBMA.
point-to-point
Sets the network type to point-to-point.
Default
No default value is specified
Command Mode
Router mode
Applicability
This command was introduced in OcNOS-SP version 4.2.
Examples
#configure terminal
(config)#router ospf 100
(config-router)#area 1 interface xe1 network-type point-to-point
Last modified date: 07-13-2023