ipv6 pim bsr-candidate
Use this command to give the router the candidate BSR status using the name the interface.
Use the no option with this command to disable this function.
Note: This command does not set up multicast boundaries. It only sets up a PIM domain BSR message candidate
Command Syntax
ipv6 pim (vrf NAME|) bsr-candidate IFNAME
no ipv6 pim (vrf NAME|) bsr-candidate
Parameters
vrf
The VPN routing/forwarding instance
NAME
Specify the name of the VPN routing/forwarding instance
IFNAME
Specify the name of the interface
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#ipv6 pim bsr-candidate eth0
(config)#no ipv6 pim bsr-candidate
Last modified date: 07-14-2023