ipv6 pim cisco-register-checksum
Use this command to configure the option to calculate the register checksum over the whole packet. This command is used to inter-operate with older Cisco IOS versions.
Use the no option with this command to revert to the default settings.
Command Syntax
ipv6 pim cisco-register-checksum
ipv6 pim cisco-register-checksum group-list (<1-99>|<1300-1999>|WORD)
ipv6 pim (vrf NAME|) cisco-register-checksum
ipv6 pim (vrf NAME|) cisco-register-checksum group-list (<1-99>|<1300-1999>|WORD)
no ipv6 pim cisco-register-checksum
no ipv6 pim cisco-register-checksum group-list (<1-99>|<1300-1999>|WORD)
no ipv6 pim (vrf NAME|) cisco-register-checksum
no ipv6 pim (vrf NAME|) cisco-register-checksum group-list (<1-99>|<1300-1999>|WORD)
Parameters
vrf
The VPN routing/forwarding instance.
NAME
Specify the name of the VPN routing/forwarding instance.
group-list
Use this parameter to configure the option to calculate the register checksum over the whole packet on multicast groups specified by the access-list.
<1-99>
Specify an IP standard access-list.
<1300-1999>
Specify an IP access-list (expanded range).
WORD
IP named standard access list.
Default
This command is disabled by default. By default, Register Checksum is calculated only over the header.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#ipv6 pim cisco-register-checksum
(config)#ipv6 pim cisco-register-checksum group-list G1
(config)#ipv6 access-list filter permit ff1e:10/128
Last modified date: 07-14-2023