no refresh-path-parsing
Use this command to disable parsing of Refresh PATH messages received from upstream nodes. Enable this command to minimize message processing by RSVP, if you are sure that a particular router does not need to parse Refresh-PATH messages to check for changes because LSPs passing through this router are not required to be updated, simultaneously.
Use the
refresh-path-parsing command to revert to the default settings.
Command Syntax
no refresh-path-parsing
Parameters
None
Default
By default, refresh-path-parsing is enabled.
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
Router#configure terminal
Router(config)#router rsvp
Router(config-router)#no refresh-path-parsing
Last modified date: 07-13-2023