show coherent-module faws
Use this command to show faults, alarms, and warnings (FAWS) and status of coherent module.
Command Syntax
show coherent-module SLOTNUMBER faws
Parameters
SLOTNUMBER
Slot number of the coherent module
Default
None
Command Mode
Exec mode
Applicability
This command was introduced in OcNOS-OTN version 1.0.2.
Example
This command will only display the current FAWS of the module.
When none of the FAWS are raised.
#show coherent-module 6 faws
-------------------------------------------------------------------------------------
Fault & Status
-------------------------------------------------------------------------------------
-------------------------------------------------------------------------------------
Alarm & Warning
-------------------------------------------------------------------------------------
When raised, all supported FAWS along with an event is displayed as a sample.
-------------------------------------------------------------------------------------
Fault & Status
-------------------------------------------------------------------------------------
Module General Status : TX-Loss-Of-Signal-Functionality
------------------------------------------------------------------------------------
Alarm & Warning
-------------------------------------------------------------------------------------
Module Alarm and Warning :
Temperature : Temperature Low-Warning
Voltage-supply : Power(Vcc) Low-Alarm
Network-Lane 0 Alarm & Warning :
Input-Power : Input-Power High-Alarm
Output-Power : Output-Power Low-Alarm
preFECBER Signal : PreFECBER Signal Failure Alarm
RX-Training-Sequence : [LOL]Loss-of-lock
RX-OTU-Alarms : [LOF]Loss-Of-Frame
RX-ODU-Alarms : [BDI]Backward-Defect-Indication
RX-OPU-Alarms : [CSF]Client-Signal-Fail
Hostif 0 PCS Alarms
Ingress-PCS-Alarms : Loss-Of-Block-Lock
Egress-PCS-Alarms : Remote-Fault
Last modified date: 07-14-2023