monitor session
Use this command to create a local or remote monitor session. By default, a local monitor session is created.
A monitor session consists of:
• A single destination interface, referred to as a mirror-to port or a single remote destination
• One or more source interfaces (egress, ingress, or both)
• One or more VLAN sources in the ingress direction
• One or more filters that can be applied to filter the mirrored packets
Use the no parameter to delete a monitor session.
Command Syntax
monitor session <1-18> ( | type ( local | remote ))
no monitor session ( <1-18> | all )
Parameters
<1-18>
Session number
local
Create a local session
remote
Create a remote source node session
all
All sessions
Default
By default, monitor session type is local and will not be active by default
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#monitor session 1
(config-monitor)#exit
(config)#monitor session 3 type remote
(config-monitor)#exit
(config)#no monitor session 1
Last modified date: 07-14-2023