Maxpoll and Minpoll Configuration
The maximum poll interval are specified in defaults to 6 (64 seconds), but can be increased by the maxpoll option to an upper limit of 16 (18.2 hours). The minimum poll interval defaults to 4 (16 seconds), and this is also the minimum value of the minpoll option.
The client will retry between minpoll and maxpoll range configured for synchronization with the server.
Client
#configure terminal | Enter configure mode. |
(config)#feature ntp vrf management | Configure feature on default or management VRF. By default this feature runs on management VRF. |
(config)#ntp server 10.1.1.1 maxpoll 7 minpoll 5 vrf management | Configure minpoll and maxpoll range for ntp server. |
(config)#exit | Exit from the Configure Mode. |
Validation Commands
#show ntp peers
-----------------------------------------------------------
Peer IP Address Serv/Peer
-----------------------------------------------------------
10.1.1.1 Server (configured)
#show ntp peer-status
Total peers : 1
* - selected for sync, + - peer mode(active),
- - peer mode(passive), = - polled in client mode
remote refid st t when poll reach delay offset jitter
==============================================================================
*10.1.1.1 LOCAL(0) 7 u 14 32 37 0.194 -4.870 3.314
Last modified date: 07-14-2023