bfd-firmware
Use this command to enable multi-hop or micro-BFD processing in hardware.
Note: For LAG interfaces, you must specify micro-bfd. With micro-bfd only single hop sessions are supported.
Command Syntax
bfd-firmware (multi-hop|micro-bfd)
Parameter
multi-hop
Enable multihop sessions
micro-bfd
Enable micro-BFD sessions (default)
Default
By default, micro-BFD sessions are enabled.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#bfd-firmware multi-hop
Last modified date: 08/28/2023