priority (queuing)
Use this command to configure a single output queuing class as the priority queue.
Note: Priority can be set only on default queues (such as queues in the default queuing policy-map).
Command Syntax
priority
Parameters
None
Default
No default value is specified. Higher priority queue will have higher priority always when set.
Command Mode
Policy map-class type queuing mode
Applicability
This command was introduced before OcNOS version 1.3.
This command applies only to the Trident II, Trident II+, and Tomahawk platforms.
Examples
#configure terminal
(config)#policy-map type queuing default default-out-policy
(config-pmap-que)#class type queuing default q0
(config-pmap-c-que)#priority
Last modified date: 07/14/2023