bridge-group spanning-tree

OcNOS-RON : Layer 2 Guide : Layer 2 Command Reference : Spanning Tree Protocol Commands : bridge-group spanning-tree

Use this command to enable or disable spanning-tree on an interface.

Command Syntax

bridge-group <1-32> spanning-tree (disable|enable)

Parameters

<1-32>

Bridge group ID.

disable

Disable spanning tree on the interface.

enable

Enable spanning tree on the interface.

Default

By default, spanning-tree is enabled

Command Mode

Interface mode

Applicability

This command was introduced before OcNOS version 1.3.

Example

(config)#interface eth1

(config-if)#bridge-group 1 spanning-tree enable

Last modified date: 07/13/2023