customer-spanning-tree provider-edge priority
Use this command to set the port priority for a provider-edge port in the customer spanning tree.
Command Syntax
customer-spanning-tree provider-edge svlan <1-4094> priority <0-240>
Parameters
<1-4094>
Specify the SVLAN identifier of provider edge port.
<0-240>
Specify the port priority (a lower priority means greater likelihood of the interface becoming root). The priority values can only be set in increments of 16.
Default
By default, priority is 1
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface eth1
(config-if)#customer-spanning-tree provider-edge svlan 2 priority 0
Last modified date: 07/13/2023