Configuring Port Breakout (100G to 2x50G)
Configuring Port Breakout (100G to 2x50G) is provided in below section.
#configure terminal | Enter configure mode. |
(config)#interface ce1/1 | Specify the interface (ce1/1) to be configured for port Breakout. |
(config-if)#port breakout enable 2x50g | Configure port breakout on interface |
(config-if)#exit | Exit interface mode. |
Note: Interface ce1/1 is back to back connected and interfaces are up.
Validation
VLAN-reservation validation
#show vlan-reservation
VLAN ID Status
======= ======
4050 allocated
4051 allocated
4052 allocated
4053 allocated
4054 allocated
4055 allocated
4056 free
4057 free
4058 free
#show interface brief
Codes: ETH - Ethernet, LB - Loopback, AGG - Aggregate, MLAG - MLAG Aggregate
FR - Frame Relay, TUN -Tunnel, PBB - PBB Logical Port, VP - Virtual Port
CVP - Channelised Virtual Port, METH - Management Ethernet, UNK- Unknown
ED - ErrDisabled, PD - Protocol Down, AD - Admin Down, IA - InActive
PD(Min-links) - Protocol Down Min-links
DV - DDM Violation, NA - Not Applicable
NOM - No operational members, PVID - Port Vlan-id
Ctl - Control Port (Br-Breakout/Bu-Bundle)
--------------------------------------------------------------------------------
Ethernet Type PVID Mode Status Reason Speed Port Ctl Br/Bu
Interface Ch #
--------------------------------------------------------------------------------
ce1/1 ETH -- routed up none 50g -- Br Yes
ce1/2 ETH -- routed down IA -- -- No No
ce1/3 ETH -- routed up none 50g -- No No
ce1/4 ETH -- routed down IA -- -- No No
Last modified date: 07/13/2023