ipv6 mld last-member-query-count
Use this command to set the last-member query-count value. This command applies to interfaces configured for MLD Layer-3 multicast protocols, or MLD Proxy.
Use the no parameter with this command to return to the default value on an interface.
Command Syntax
ipv6 mld last-member-query-count <2-7>
no ipv6 mld last-member-query-count
Parameters
<2-7>
Specify a last-member query-count value.
Default
The default last-member query-count value is 2.
Command Mode
Interface mode for VLAN interface
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#interface 0
(config-if)#ipv6 mld last-member-query-count 3
Last modified date: 07/14/2023