ipv6 nd managed-config-flag
Use this command to set the managed address configuration flag in the Router Advertisement to be used for the IPv6 address auto-configuration.
Use the no parameter with this command to reset the value to default.
Command Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Parameters
None
Default
The managed address configuration flag is not set.
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#interface eth3
(config-if)#ipv6 nd managed-config-flag
(config-if)#no ipv6 nd managed-config-flag
Last modified date: 08/28/2023