ipv6 nd other-config-flag
Use this command to set the other stateful configuration flag in Router Advertisement to be used for IPv6 address auto-configuration.
Use no parameter with this command to reset the value to default.
Command Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Parameters
None
Default
Other stateful configuration flag is not set.
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#interface eth3
(config-if)#ipv6 nd other-config-flag
Last modified date: 08/28/2023