cisco-metric-behavior
Use this command to enable or disable the metric update as Cisco.
Use the no parameter with this command to disable this feature.
Command Syntax
cisco-metric-behavior (enable|disable)
no cisco-metric-behavior
Parameters
enable
Enable updating the metric consistent with Cisco.
disable
Disable updating the metric consistent with Cisco.
Default
By default, the Cisco metric-behavior is disabled.
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
This example shows how to enable the metric update behavior to be consistent with Cisco in the Router mode.
#configure terminal
(config)#router ipv6 rip
(config-router)#cisco-metric-behavior enable
Last modified date: 08/28/2023