distribute-list
Use this command to filter incoming or outgoing route updates using the access-list or the prefix-list. You can filter out incoming or outgoing route updates using access-list or prefix-list. If you do not specify the name of the interface, the filter will be applied to all the interfaces.
Use the no parameter with this command to disable this feature.
Command Syntax
distribute-list WORD (in|out) (IFNAME|)
distribute-list prefix WORD (in|out) (IFNAME|)
no distribute-list (in|out) (IFNAME|)
no distribute-list prefix (in|out) (IFNAME|)
Parameters
WORD
Specify the IPv6 access-list number or name to use.
prefix
Filter prefixes in routing updates.
WORD
Specify the name of the IPv6 prefix-list to use.
in
Filter incoming routing updates.
out
Filter outgoing routing updates.
IFNAME
Specify the name of the interface on which distribute-list applies.
Default
Disabled
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3 and modified in OcNOS version 6.1.0.
Example
#configure terminal
(config)#router ipv6 rip
(config-router)#distribute-list prefix myfilter in eth0
Last modified date: 08/28/2023