offset-list
Use this command to add an offset to in and out metrics to routes learned through RIPng.
Use the no parameter with this command to remove this function.
For more details about this command, see the IPv4 version of this command (
offset-list).
Command Syntax
offset-list WORD (in|out) (IFNAME|)
no offset-list in|out (IFNAME|)
Parameters
WORD
Specify the access-list number or names to apply.
in
Indicates the access list will be used for metrics of incoming advertised routes.
out
Indicates the access list will be used for metrics of outgoing advertised routes.
IFNAME
An alphanumeric string that specifies the interface to match.
Default
The default offset value is the metric value of the interface which is defined by the operating system.
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3 and modified in OcNOS version 6.1.0.
Examples
In this example the router examines the RIP updates being sent out from interface eth0 and adds 16 hops to the routes matching the ip addresses specified in the access list accesslist1.
#configure terminal
(config)#router ipv6 rip
(config-router)#offset-list accesslist1 in eth0
Last modified date: 08/28/2023