show ipv6 rip interface
Use this command to display information about the RIPng interfaces. You can specify an interface name to display information about a specific interface.
Command Syntax
show ipv6 rip interface (IFNAME|)
Parameters
IFNAME
Name of the interface for which information is to be displayed.
Command Mode
Exec mode and Privileged Exec mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
The following is a sample output from the show ipv6 rip interface command.
#show ipv6 rip interface
lo is up, line protocol is up
RIPng is not enabled on this interface
eth0 is up, line protocol is up
RIPng is not enabled on this interface
eth1 is down, line protocol is down
RIPng is not enabled on this interface
eth2 is up, line protocol is up
Routing Protocol: RIPng
Passive interface: Disabled
Split horizon: Enabled with Poisoned Reversed
IP interface address:
3ffe:ffff::1/64
3ffe:fffe::1/64
Last modified date: 08/28/2023