load-balance rtag7 vxlan inner-l3
Use this command to enable RTAG7 load balancing for VxLAN for inner-L3 IPv4 and IPv6 packets on the access side for load sharing of traffic on tunnel paths. This command also enables random UDP source port generation for the VxLAN UDP tunnels based on the L3 frame being received on the VxLAN access port.
Use the no parameter of this command to disable load balance for RTAG7 for VxLAN for inner-L3 IPv4 and IPv6 frames.
Command Syntax
load-balance rtag7 vxlan inner-l3 (dest-ip | destl4-port | protocol-id | src-ip | srcl4-port)
no load-balance rtag7 vxlan inner-l3 (dest-ip | destl4-port | protocol-id | src-ip | srcl4-port)
Parameter
dest-ip
Destination IP.
destl4-port
Destination l4 port.
protocol-id
Protocol (IPv4).
src-ip
Source IP.
srcl4-port
Source l4 port.
Default
By default, the load-balance rtag7 vxlan inner-l3 default is src-ip.
Command Mode
Configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#load-balance rtag7 vxlan inner-l3 dest-ip
(config)#no load-balance rtag7 vxlan inner-l3 dest-ip
Last modified date: 08/28/2023