hardware-profile micro-bfd

OcNOS-SP : Layer 3 Guide : Bidirectional Forwarding Detection Command Reference : Bidirectional Forwarding Commands : hardware-profile micro-bfd

Use this command to enable micro-BFD support on hardware.

Note: Micro-bfd support is optional when a BFD session is configured over a LAG interface between two Qumran devices. It is mandatory to enable micro-bfd when the BFD session is configured over LAG interface between different platforms. When BFD sessions are configured over LAG interfaces, both Qumran nodes should have micro-bfd enabled or disabled.

Command Syntax

hardware-profile micro-bfd (enable|disable)

Parameter

enable

Enable micro-bfd support on Qumran

disable

Disable micro-bfd support on Qumran

Default

By default, micro-bfd support is disabled on Qumran.

Command Mode

Configure mode

Applicability

This command was introduced in OcNOS version 3.0.

Example

#configure terminal

(config)# hardware-profile micro-bfd enable

Last modified date: 08/28/2023