neighbor strict-capability-match
Use this command to close the BGP connection if a capability value does not match the remote peer.
Use the no parameter with this command to disable this function.
Command Syntax
neighbor (A.B.C.D|X:X::X:X|WORD) strict-capability-match
no neighbor (A.B.C.D|X:X::X:X|WORD) strict-capability-match
For BGP unnumbered mode:
neighbor WORD strict-capability-match
no neighbor WORD strict-capability-match
Parameters
A.B.C.D
Address of the BGP neighbor in an IPv4 format
X:X::X:X
Address of the BGP neighbor in an IPv6 format
WORD
Name of a BGP peer group created with the
neighbor WORD peer-group command. When you specify this parameter, the command applies to all peers in the group.
Default
By default, strict capability match is disabled
Command Mode
Router mode and BGP unnumbered mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#router bgp 12
(config-router)#neighbor 10.10.10.10 strict-capability-match
For unnumbered peer below configuration is given in BGP unnumbered-mode.
(config)#router bgp 100
(config-router)#bgp unnumbered-mode
(config-router-unnum)#neighbor eth1 strict-capability-match
Last modified date: 08/28/2023