customer-spanning-tree transmit-holdcount
Use this command to set the transmit-holdcount for a bridge.
Use the no parameter with this command to restore the default value of transmit-holdcount.
Command Syntax
customer-spanning-tree transmit-holdcount <1-10>
no customer-spanning-tree transmit-holdcount
Parameters
<1-10>
Specify the maximum number that can be transmitted per second.
Default
By default, bridge transmit hold count is 6
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
#configure terminal
(config)#interface eth1
(config-if)#customer-spanning-tree transmit-holdcount 3
(config-if)#no customer-spanning-tree transmit-holdcount
Last modified date: 07/06/2023