remote destination
Use this command to configure a destination VLAN and the reflector port for the remote monitor session.
Use the no parameter to remove a destination from a remote monitor session.
Command Syntax
destination remote vlan <2-4094> reflector-port IFNAME
no destination remote
Parameters
<2-4094>
VLAN identifier
IFNAME
Interface name
Default
No default value is specified
Command Mode
Monitor configure mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#no vlan 900 bridge 1
(config)#interface xe3
(config-if)#switchport
(config)#monitor session 1
(config-monitor)#destination remote vlan 900 reflector-port xe3
(config-monitor)#no destination remote
Last modified date: 07/06/2023