split-horizon (service-template)
Use this command to configure split-horizon group for vpls attachment circuit.
Use the no form of this command to remove split-horizon group from vpls attachment circuit.
Command Syntax
split-horizon group (network | access1 | access2)
no split-horizon group
Parameters
network
Split-horizon group name network
access1
Split-horizon group name access1
access2
Split-horizon group name access2
Default
By default, split horizon is disabled.
Command Mode
Interface VPLS mode
Applicability
This command was introduced before OcNOS version 6.3.0 and applicable only on Qumran1 devices.
Examples
#configure terminal
(config)#interface xe1
(config-if)#switchport
(config-if)#mpls-vpls vpls1 service-template vc1
(config-if-vpls)#split-horizon group access1
(config-if-vpls)#no split-horizon group
Last modified date: 07/17/2023