tunnel-select-policy
Use this command to set tunnel-policy for a VPLS instance. This command is used for BGP signaling based VPLS instance. This will be used while selecting transport for the peer.
Use the no parameter with this command to un-configure tunnel selection policy.
Command Syntax
tunnel-select-policy TNLPOLICYNAME
no tunnel-select-policy
Parameters
TNLPOLICYNAME
Name of tunnel policy
Command Mode
VPLS SIG mode
Applicability
This command was introduced before OcNOS version 4.2.
Examples
#configure terminal
(config)#mpls vpls vpls1 10
(config-vpls)#signaling bgp
(config-vpls-sig)#tunnel-select-policy policy1
Last modified date: 07/17/2023