ip rip send version
Use this command to send RIP packets on an interface using version control. In addition to version 1 and version 2, compatible version packets can be specified. With the parameter 1-compatible, a version 2 RIP interface will broadcast the packets instead of multicasting them.
This command applies to a specific interface and overrides any the version specified by the version command.
Use the no parameter with this command to use the global RIP version control rules.
Command Syntax
ip rip send version (1|2|1-compatible)
ip rip send version 1 2
ino ip rip send version
Parameters
1
Specify sending RIP version 1 packets out of an interface.
2
Specify sending RIP version 2 packets out of an interface.
1 2
Specify acceptance of RIP version 1 and version 2 packets on the interface.
1-compatible
Specify sending RIP version 1 compatible packets from a version 2 RIP interface.
Default
Version 2
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3 and modified in OcNOS version 6.1.0.
Examples
In the following example, interface eth1 is configured to send both RIP version 1 and 2 packets.
#configure terminal
(config)#interface eth1
(config-if)#ip rip send version 1 2
Last modified date: 08/28/2023