OcNOS-SP : Timing and Synchronization Guide : Synchronous Ethernet Command Reference : SyncE Commands : clock-source-id
clock-source-id
Use this command to set the clock source ID for Synchronous Ethernet interface.
Use the no form of this command to unset this value.
Note: Assign the same clock source ID if interfaces are connected to same clock source.
Command Syntax
clock-source-id <1-255>
no clock-source-id
Parameters
<1-255>
Clock Source ID.
Command Mode
Interface Synchronous Ethernet Mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
#configure terminal
(config)#interface xe1
(config-if)#synce
(config-if-synce)#clock-source-id 1
Last modified date: 06/30/2023