hold-off
Use this command to set the hold-off time in milliseconds. The hold-off time ensures that short activation of signal fail is not passed to the selection process.
Use the no form of this command to set the default value (300 milliseconds).
Command syntax
hold-off <300-1800>
no hold-off
Parameters
<300-1800>
Hold-off time in milliseconds
Default
The default value is 300 milliseconds.
Command Mode
Interface Synchronous Ethernet mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
(config)#interface eth1
(config-if)#synce
(config-if-synce)#hold-off 500
(config-if-synce)#no hold-off
Last modified date: 06/30/2023