synce-interface
Use this command to enable Synchronous Ethernet for both GPS and 10MHz interfaces as input interfaces. This command changes the mode from interface mode to Synchronous interface Ethernet mode.
Use no form of this command to delete synce interface.
Note: Bits-e1 Applicable only for UFI-S9500-30XS, UFI-S9500-22XST, AS7316-26XB boards.
Note: Bits-t1 Applicable only for UFI-S9500-30XS, UFI-S9500-22XST boards.
Command Syntax
synce-interface (gps | 10mhz-in|ptp|bits-t1|bits-e1)
no synce-interface (gps | 10mhz-in|ptp |bits-t1|bits-e1)
Parameters
gps
Input interface as GPS
10mhz-in
Input interface as 10MHz
ptp
PTP interface as input-source
bits-t1
bits-t1 interface as input-source
bits-e1
bits-e1 interface as input-source
Command Mode
Interface mode
Applicability
This command was introduced in OcNOS version 4.0.
Example
(config)#interface eth1
(config-if)#synce-interface gps
(config-synce-if)#
(config)#synce-interface bits-t1
(config-synce-if)#
Last modified date: 06/30/2023