wait-to-restore
Use this command to set the wait-to-restore timer in minutes. The wait-to-restore time ensures that a synchronization source that previously failed is considered by the selection process again only if it is fault free for a certain time.
Use the no form of this command to set the default wait-to-restore time (5 minutes).
Command syntax
wait-to-restore <0-12>
no wait-to-restore
Parameters
<0-12>
Wait-to-restore time in minutes
Default
The default value is 5 minutes.
Command Mode
Interface Synchronous Ethernet mode
Applicability
This command was introduced before OcNOS version 1.3.
Examples
(config)#interface eth1
(config-if)#synce
(config-if-synce)#wait-to-restore 1
(config-if-synce)#no wait-to-restore
Last modified date: 06/30/2023