ipv4-exclude-pseudo-header
Use this command to exclude the pseudo-header in IPv4 VRRPv3 checksum calculation on the VRRP group in router mode to support IPv4 VRRPv3 interoperability.
Note: Use this command when checksum errors are observed with other vendors for VRRPv3.
Use the no form of this command to delete the VRRP IPv4 checksum pseudo-header exclude configuration from the VRRP group on the router.
Command Syntax
ipv4-exclude-pseudo-header
Parameter
None
Default
Disabled
Command Mode
Router mode
Applicability
This command was introduced in OcNOS-SP version 2.4.
Examples
#configure terminal
(config)#router vrrp 2 eth2
(config-router)#ipv4-exclude-pseudo-header
#configure terminal
(config)#router vrrp 2 eth2
(config-router)#no ipv4-exclude-pseudo-header
Last modified date: 08/28/2023