operational-ip
Use this command to set the primary IPv4 address.
Use the no parameter with this command to remove a primary IPv4 address.
Command Syntax
operational-ip A.B.C.D
no operational-ip
Parameters
A.B.C.D
IPv4 address.
Default
No default value is specified
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
#configure terminal
(config)#router vrrp 1 eth0
(config-router)#operational-ip 1.2.3.4
Last modified date: 08/28/2023