OcNOS-SP : Layer 3 Guide : Virtual Router Redundancy Protocol Command Reference : VRRP v6 Commands : disable
disable
Use this command to disable a VRRP session on the router (to stop the router from participating in virtual routing). Refer to enable to enable a VRRP session on the router.
When this command is configured, a backup router assumes the role of master depending on its priority.
Command Syntax
disable
Parameters
None
Command Mode
Router mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
The example below shows to disable VRRP session.
#configure terminal
(config)#router ipv6 vrrp 1 eth0
(config-router)#disable
Last modified date: 08/28/2023