bfd echo ipv4 source
Use this command to set the echo ipv4 source address.
Use the no form of this command to reset the value.
Command Syntax
bfd echo ipv4 source A.B.C.D
no bfd echo ipv4 source
Parameter
A.B.C.D
Source IPv4 address.
Command Mode
Interface mode
Applicability
This command was introduced before OcNOS version 1.3.
Example
The following command displays the ipv4 source address value.
#configure terminal
(config)#interface eth1
(config-if)#bfd echo interval 234
(config-if)#bfd echo ipv4 source A.B.C.D
Last modified date: 10/16/2023