show ip bgp vpnv6 rd neighbors
Use this command to display VPNv6 NLRI information for a given route distinguisher and optionally for a given neighbor.
Command Syntax
show ip bgp vpnv6 rd WORD neighbors
show ip bgp vpnv6 rd WORD neighbors (A.B.C.D|X:X::X:X)
Parameters
WORD
Route distinguisher
A.B.C.D
IPv4 neighbor address
X:X::X:X
IPv6 neighbor address
Command Mode
Privileged Exec mode and Exec mode
Applicability
This command was introduced in OcNOS version 3.0.
Example
#show ip bgp vpnv6 rd 1:1 neighbors
BGP neighbor is 10.32.0.3, remote AS 1, local AS 1, internal link
BGP version 4, local router ID 10.32.0.2, remote router ID 10.32.0.3
BGP state = Established, up for 00:43:57
Last read 00:00:08, hold time is 90, keepalive interval is 30 seconds
Neighbor capabilities:
Route refresh: advertised and received (old and new)
Address family IPv4 Unicast: advertised and received
Address family VPNv4 Unicast: advertised and received
Address family VPNv6 Unicast: advertised and received
Received 25726 messages, 0 notifications, 0 in queue
Sent 25689 messages, 1 notifications, 0 in queue
Route refresh request: received 0, sent 0
Minimum time between advertisement runs is 5 seconds
Update source is lo
For address family: IPv4 Unicast
BGP table version 1, neighbor version 1
Index 1, Offset 0, Mask 0x2
Community attribute sent to this neighbor (both)
0 accepted prefixes
0 announced prefixes
For address family: VPNv4 Unicast
BGP table version 837, neighbor version 837
Index 1, Offset 0, Mask 0x2
Community attribute sent to this neighbor (both)
0 accepted prefixes
0 announced prefixes
For address family: VPNv6 Unicast
BGP table version 302, neighbor version 302
Index 1, Offset 0, Mask 0x2
Community attribute sent to this neighbor (both)
0 accepted prefixes
0 announced prefixes
Connections established 2; dropped 1
Last modified date: 10/16/2023